T8 glass tube

Led T8 glass lamp

Rated voltage: 95v-265v / 60Hz, 220V / 50Hz

Color temperature selection: 6500k / 4100k / 3000K red / Green / Blue / Pink

Lamp bead model: SMD 2835

Width and height of lamp body: Ф 27mm

Shade color: milky white, transparent

As people's living standards are constantly improving, people pay more and more attention to the environment and health, so the green LED flat lamp is naturally more and more popular. In this era of green and environmental protection, green product l and consumption mode will occupy most of the market. Duosheng lighting manufacturers are also constantly improving their technical level, paying attention to the environmental protection performance of lamps and lanterns, so that people can use truly green and harmless lamps and lanterns, and truly realize the life of low-carbon and environmental protection

It is only a few years since the appearance of LED purification lamp series products. Since its birth, it has been favored by the majority of users. At present, more than 90% of new dust-free workshops have been built. However, most of the dust-free workshops previously built use traditional lighting lamps, which consumes a lot of energy. Many companies consider replacing them with LED purification lamps, but the cost of replacing LED lamps as a whole is relatively high, which is not recommended For overall replacement, it can be considered to use the original lamps and then replace the lighting tubes, and replace the original tubes with LED tubes. Here is an introduction to the replacement methods of LED tubes:

The original lamp rack is equipped with inductive ballast. If the starter is removed, the original rectifier shall be short circuited or removed; the starter must be removed, otherwise the power supply of LED fluorescent lamp will be damaged.

If electronic rectifier is installed in the original lamp rack, the starter and electronic rectifier must be removed, otherwise the LED fluorescent lamp will not be on.

In the lighting transformation, due to the high position of fluorescent lamps, we must pay attention to safety during operation. Duosheng lighting recommends two people in a group, one working on it and one protecting on the ground, so as to prevent accidents, live operation and electric shock.

In the components of LED panel lamp of t5t8 fluorescent lamp manufacturer, the cost of LED light source, aluminum frame of panel lamp, light guide plate and LED driver accounts for a large proportion, while other costs such as diffusion plate, reflector and labor cost are relatively low.

It needs to be reminded that in order to save time and materials, some installers have to install the LED fluorescent lamp directly after removing the starter. The LED fluorescent lamp will also light up and work under high pressure for a long time. After about 3000 hours, the light of the LED fluorescent lamp will decline seriously until it is scrapped. We hope that

Attention of t5t8 fluorescent lamp manufacturers and users!